Boiler Passport

INSTALLATION ENGINEER DETAILS

OFTEC Registration Number	Date of Installation*	Choose Date

Installation Engineer Name & Address*



Installation Engineer Contact Details*

COMMISSIONING ENGINEER DETAILS

Check here if the Commissioning Engineer details are the same as Installation Engineer details

OFTEC Registration Number	Date of Commisioning*	Choose Date

Commisioning Engineer Name & Address*



Commissioning Engineer Contact Details*

APPLIANCE & INSTALLATION DETAILS

Appliance Make & Model
Appliance Serial No.*		Date Code

Burner Make & Model*
Burner Serial No.*		Burner Code

Householder's Name & Address*



Householder's Contact Details



New SystemReplacement		Open VentedSealed System
Automatic Bypass fitted to system?*	YesNo

COMMISSIONING PROCEDURE INFORMATION

For All Installations

Has the system been flushed?

YesNo

What cleanser was used?

Has an inhibitor been added?

YesNo

Which inhibitor was used?

Has a remote acting fire valve been fitted?*

YesNo

Oil supply configuration:*

1 pipe2 pipeDe-aerator

If 2-pipe or de-aerator, has bypass been fitted to oil pump?

YesNo

Has a fuel filter with a micron rating <70μm been fitted?*

YesNo

For Sealed System Only

Expansion vessel volume

Litres

System pressure (Cold)

bar

Vessel pre-charge pressure

bar

System pressure (Hot)

bar

For Condensing Boilers Only

Has the condensate drain been correctly fitted?

YesNo

For All Boilers

Digital Flue Gas Analyser Make & Model*

Boiler Performance		Burner Settings
Efficiency (nett)	%	Nozzle Size*		Air Damper Setting*
CO2 Concentration*	%	Nozzle Angle*	°	Adjustable Head Setting
CO Concentration	%	Nozzle Pattern*		Conventional Flue Draught	mbar
Flue Gas Temerature*	°C	Oil Pump Pressure*		Oil Pump Vacuum	bar
Smoke Number*		Fuel Type*	28 sec35 secOther

Additional Requirements for Combi Boilers

Have you tested the hardness of the mains water?

YesNo

Is hard water treatment required (see guidance in Boiler Manual)

YesNo

If required, has a suitable and effective hard water treatment been fitted?

YesNo

What Type?

Has a pressure reducing valve been fitted?

YesNo

Set to what pressure?

bar

Incoming Mains Water

Domestic Hot water

Flow Rate

L/min

Flow Rate

L/min

Temperature

°C

Temperature

°C

For All Installation

Does the heating and hot water system comply with the appropriate Building Regulations?*

YesNo

Has the appliance, flue system and associated equipment been installed and commissioned in accordance with the manufacturer's instructions?*

YesNo

Have the appliance and controls been wired in accordance with local and European electrical regulations in force at the time?*

YesNo

Have you checked the completeinstallation (including boiler, flue, radiators, pipework, tank and fuel line) for water, oil or gas leaks?*

YesNo

Have you demonstrated the operation of the appliance and system controls to the customer?*

YesNo

Have you left all of the manufacturer's literature and this passport with the customer?*

YesNo

Has the necessary provision for combusition and ventilation air as required by BS5410 and the appliance manufacturer's instructions been provided?*

YesNo

Where the completion of CD10 and CD11 documentation is a requirement of the Building Regulations, have these been completed?*

YesNo

Important Comments:

I am, or have the authority to act on behalf of, the Commissioning Engineer and do hereby certify that the information provided herein is, to the best of my knowledge, complete and accurate. 1

To help keep your details accurate we may use information we receive from our partners. You can ask for a copy of your details (for a small fee) and to correct any inaccuracies. To make sure we follow your instructions correctly and to improve our service we may monitor or record our communications with you. Please note that failure to provide some or all of the information requested does not affect your statutory rights but may affect the quality of the service provided.

Your details will be used by the manufacturer to provide customer services, information about extended warranties and for other marketing purposes. They will disclose your information to their service providers and agents for these purposes. Your details may also be used by other third parties for other marketing purposes. The manufacturer and the third parties may contact you by mail, email or telephone. If you do not wish for them to use your data for other marketing purposes check this box. 1

Please double check everything you have entered in the form. Mistakes cannot be rectified after you click submit.